Chapter 4 — Cable & Antenna Analyzer Mode Commands
4-12 PN: 10580-00322 Rev. F S331L PM
:CALCulate:MARKer#:VALLey
Cmd Description: This command sets specified marker to the trace valley value.
Example: To set marker 5 to the valley of the trace:
:CALC:MARK5:VALL
Notes: Replace ’#’ with the required marker number. Check User Guide for the
number of supported markers in each mode.
:CALCulate:MARKer#:VALLey:BOUNded
Cmd Description: This command sets specified marker to the trace valley value between
two markers. Markers 5 and 7 will search for the valley between
markers 1 and 2. Markers 6 and 8 will search for the valley between
markers 3 and 4.
Example: To set marker 5 to the valley between markers 1 and 2:
:CALC:MARK5:VALL:BOUN
Notes: Replace ’#’ with the required marker number. Check User Guide for the
number of supported markers in each mode. If any marker other than 5,
6, 7, or 8 is specified, the bounded marker will be set to 5 by default.
:CALCulate:MARKer#:X
<value>{Hz|kHz|MHz|GHz,m|cm|mm,ft,ps|ns|us|ms|s}
:CALCulate:MARKer#:X?
Cmd Description: Command sets the position for the specified marker in the current
sweep domain. For delta marker, it sets the relative position to the
reference marker. Verify that the appropriate unit is used. Time units
are available only if option 2 is installed.
Query Description: Query returns the marker position for the specified marker. For a delta
marker, query returns the position relative to the reference marker.
Param Type: Float
Param Description: Frequency, distance, or time
Default Value: Model-dependent
Default Units: Hz
Example: To set marker 2 frequency to 1 GHz:
:CALC:MARK2:X 1 GHZ
Notes: Replace ’#’ with the required marker number. Check User Guide for the
number of supported markers in each mode.
To Next Page
Loading...
Need help?
General
