Anritsu Site Master S331L Scpi Programming Manual

Chapter 4 — Cable & Antenna Analyzer Mode Commands
S331L PM PN: 10580-00322 Rev. F 4-21
:INITiate#:DATA? FDATa|SDATa|FMEM|SMEM
Cmd Description: Command triggers a sweep and returns the data block of the specified
trace at the end of sweep. If the system is in continuous mode, then this
command is ignored.
Example: To trigger a sweep and wait for Formatted data to be returned:
:INIT1:DATA? FDAT
:INITiate:CONTinuous OFF|ON|0|1
:INITiate:CONTinuous?
Cmd Description: Command sets the sweep type between single sweep and continuous
sweep.
Query Description: Query returns the sweep type, single or continuous. Query returns 1 for
continuous sweep, and returns 0 for single sweep.
Param Range: OFF|ON|0|1
Default Value: ON|1
Example: To set the sweep type to single sweep:
:INIT:CONT OFF
:INITiate:HOLD OFF|ON|0|1
:INITiate:HOLD?
Cmd Description: Command sets the sweep state between run and hold. This command is
ignored in external trigger mode.
Query Description: Query returns the sweep state, run or hold. Query returns 1 for hold
mode, and returns 0 for run mode.
Param Range: OFF|ON|0|1
Default Value: OFF|0
Example: To set the sweep state to hold:
:INIT:HOLD ON
:INITiate[:IMMediate]
Cmd Description: Command triggers a single sweep if in single sweep mode. If the system
is in continuous mode, then this command is ignored.
Example: To trigger a sweep:
:INIT

Anritsu Site Master S331L Specifications

General

Brand	Anritsu
Model	Site Master S331L
Category	Measuring Instruments
Language	English