Anritsu Site Master S331L Scpi Programming Manual

Chapter 4 — Cable & Antenna Analyzer Mode Commands
4-4 PN: 10580-00322 Rev. F S331L PM
:CALCulate#:LIMit:LOWer:SEGMent:STOP:Y <amplitude>
:CALCulate#:LIMit:LOWer:SEGMent:STOP:Y?
Cmd Description: Command sets the lower limit line Y stop value for active segment.
Query Description: Query returns the lower limit line Y stop value for active segment.
Param Type: Float
Default Units: Current active trace y-axis units
Example: To set limit stop amplitude to 20 dB for trace 1:
:CALC1:LIM:LOW:SEGM:STOP:Y 20
Notes: Replace ’#’ with the required trace number. Check User Guide for the
number of supported traces in each mode.
:CALCulate#:LIMit:LOWer:SEGMent:TOTal?
Query Description: Query returns the total segments in the lower limit for the given trace.
Example: To query how many lower limit segments are currently available for
trace 1:
:CALC:LIM:LOW:SEGM:TOT?
Notes: Replace ’#’ with the required trace number. Check User Guide for the
number of supported traces in each mode.
:CALCulate#:LIMit:LOWer:Y <amplitude>{dB,s|ms|ns|ps}
:CALCulate#:LIMit:LOWer:Y?
Cmd Description: Command sets the lower limit line value. In group delay mode, the
value is in units of time.
Query Description: Query returns the lower limit line value.
Param Range: x[,dB]
Default Units: Current active trace y-axis units
Example: To set limit amplitude to 20 dB for trace 1:
:CALC1:LIM:LOW:Y 20
Notes: Replace ’#’ with the required trace number. Check User Guide for the
number of supported traces in each mode.

Anritsu Site Master S331L Specifications

General

Brand	Anritsu
Model	Site Master S331L
Category	Measuring Instruments
Language	English