Anritsu Site Master S331L Scpi Programming Manual

Chapter 4 — Cable & Antenna Analyzer Mode Commands
4-10 PN: 10580-00322 Rev. F S331L PM
:CALCulate:LIMit:UPPer:SEGMent:ACTive <Index>
Cmd Description: Command sets the given upper segment index active.
Param Type: int
Example: To set upper segment 1 active:
:CALC:LIM:UPP:SEGM:ACT 1
:CALCulate:LIMit:VALue <amplitude>{dB}
:CALCulate:LIMit:VALue?
Cmd Description: Command sets the limit line value.
Query Description: Query returns the limit line value.
Param Type: Float
Default Units: Current active trace y-axis units
Example: To set limit line to 20 dB:
:CALC:LIM:VAL 20
:CALCulate:LIMit[:STATe] OFF|ON|0|1
:CALCulate:LIMit[:STATe]?
Cmd Description: Command sets the limit line state.
Query Description: Query returns the limit line state.
Param Range: OFF|ON|0|1
Default Value: OFF|0
Example: To set limit on:
:CALC:LIM ON
:CALCulate:MARKer#:PEAK
Cmd Description: This command sets specified marker to the trace peak value.
Example: To set marker 5 to the peak of the trace:
:CALC:MARK5:PEAK
Notes: Replace ’#’ with the required marker number. Check User Guide for the
number of supported markers in each mode.

Anritsu Site Master S331L Specifications

General

Brand	Anritsu
Model	Site Master S331L
Category	Measuring Instruments
Language	English