Anritsu Site Master S331L Scpi Programming Manual

Chapter 4 — Cable & Antenna Analyzer Mode Commands
S331L PM PN: 10580-00322 Rev. F 4-7
:CALCulate#:LIMit:UPPer:SEGMent:STOP:X <value>
:CALCulate#:LIMit:UPPer:SEGMent:STOP:X?
Cmd Description: Command sets the upper limit line X stop value for active segment.
Time units are available only if option 2 is installed.
Query Description: Query returns the upper limit line X stop value for active segment.
Param Type: Float
Default Units: Hz for Frequency domain, m or ft for Distance domain, s for Time
domain
Example: To set limit X stop value to 1 MHz for trace 1:
:CALC1:LIM:UPP:SEGM:STOP:X 1000000
Notes: Replace ’#’ with the required trace number. Check User Guide for the
number of supported traces in each mode.
:CALCulate#:LIMit:UPPer:SEGMent:STOP:Y <amplitude>
:CALCulate#:LIMit:UPPer:SEGMent:STOP:Y?
Cmd Description: Command sets the upper limit line Y stop value for active segment.
Query Description: Query returns the upper limit line Y stop value for active segment.
Param Type: Float
Default Units: Current active trace y-axis units
Example: To set limit stop amplitude to 20 dB for trace 1:
:CALC1:LIM:UPP:SEGM:STOP:Y 20
Notes: Replace ’#’ with the required trace number. Check User Guide for the
number of supported traces in each mode.
:CALCulate#:LIMit:UPPer:SEGMent:TOTal?
Query Description: Query returns the total segments in the upper limit for the given trace.
Example: To query how many upper limit segments are currently available for
trace 1:
:CALC:LIM:UPP:SEGM:TOT?
Notes: Replace ’#’ with the required trace number. Check User Guide for the
number of supported traces in each mode.

Anritsu Site Master S331L Specifications

General

Brand	Anritsu
Model	Site Master S331L
Category	Measuring Instruments
Language	English