Anritsu Site Master S331L Scpi Programming Manual

Chapter 4 — Cable & Antenna Analyzer Mode Commands
S331L PM PN: 10580-00322 Rev. F 4-13
:CALCulate:MARKer#:Y?
Query Description: Query returns the amplitude value for the specified marker.
Example: To query marker 3 amplitude value:
:CALC:MARK3:Y?
Notes: Replace ’#’ with the required marker number. Check User Guide for the
number of supported markers in each mode.
:CALCulate:MARKer#[:STATe] OFF|ON|0|1
:CALCulate:MARKer#[:STATe]?
Cmd Description: Command sets the state of the specified marker.
Query Description: Query returns the state of the specified marker. Query returns 1 if the
specified marker is on, or returns 0 if the specified marker is off.
Param Range: OFF|ON|0|1
Default Value: OFF|0
Example: To set marker 1 state ON:
:CALC:MARK1 ON
Notes: Replace ’#’ with the required marker number. Check User Guide for the
number of supported markers in each mode.
:CALCulate:MARKer:ACTive?
Query Description: Query returns active marker number. Returns NONE if no markers are
active.
Example: To get active marker
:CALC:MARK:ACT?
:CALCulate:MARKer:DISPlay MKRTable|MKRonly|AOFF
:CALCulate:MARKer:DISPlay?
Cmd Description: Command sets the marker display mode.
Query Description: Query returns the marker display mode. Query returns MKRT if the
markers and marker table are displayed, returns MKR if only the
markers are displayed, or returns AOFF if markers and marker table
are not displayed.
Param Range: MKRTable|MKRonly|AOFF
Default Value: MKRTable
Example: To set marker display to marker only:
:CALC:MARK:DISP MKR

Anritsu Site Master S331L Specifications

General

Brand	Anritsu
Model	Site Master S331L
Category	Measuring Instruments
Language	English