Chapter 4 — Cable & Antenna Analyzer Mode Commands
S331L PM PN: 10580-00322 Rev. F 4-23
[:SENSe]:APPLication:TST:RESult?
Query Description: Query returns self-test details. The self-test command (See
[:SENSe]:APPLication:TST? [NORMal]) must be sent before getting the
self-test details.
Example: To retrieve application self-test result:
:APPL:TST:RES?
Notes: The response begins with an ASCII header. The header specifies the
number of following bytes. It appears in the format #AX, where A is the
number of digits in X, and X is the number of bytes that follow the
header. The first information of the result contains the overall self test
string ("PASSED" or "FAILED") followed by a comma, and each self-test
result separated by a comma. Each subset of the result is included in
angled brackets.
[:SENSe]:APPLication:TST? {NORMal}
Query Description: Query returns 0 if self-test succeeds with no error. Otherwise, it returns
255.
Param Description: Optional Param: Self-test type, default is NORMal.
Param Range: NORMal
Example: To run an application self-test:
:APPL:TST?
[:SENSe]:CALibration:STATe?
Query Description: Query returns the state of calibrated measurements depending on the
calibration collection type. 0 means no calibration was done. For
calibration types RFP1 & RRP1, return value is 1. For calibration types
TRFP & TRES, return value is 4. For calibration types 2PFP & 2PES,
return value is 5.
Example: To query state after calibration is completed:
:CAL:STAT?
[:SENSe]:CORRection:COLLect:ABORt
Cmd Description: Aborts all steps of the RF calibration.
Example: To abort RF calibration:
:CORR:COLL:ABOR
To Next Page
Loading...
Need help?
General
