Anritsu Site Master S331L Scpi Programming Manual

Chapter 4 — Cable & Antenna Analyzer Mode Commands
S331L PM PN: 10580-00322 Rev. F 4-5
:CALCulate#:LIMit:LOWer[:STATe] OFF|ON|0|1
:CALCulate#:LIMit:LOWer[:STATe]?
Cmd Description: Command sets the low limit line state for the specified trace.
Query Description: Query returns the lower limit line state for the specified trace.
Param Range: OFF|ON|0|1
Default Value: OFF|0
Example: To set limit on for trace 1:
:CALC1:LIM:LOW ON
Notes: Replace ’#’ with the required trace number. Check User Guide for the
number of supported traces in each mode.
:CALCulate#:LIMit:UPPer:SEGMent:ADD
<StartX><StopX><StartY><StopY>
Cmd Description: Command adds a segment to the upper limit line.
Param Type: Float
Default Units: X units: Hz for Frequency domain, m or ft for Distance domain; Y units:
same as current active trace y-axis units
Example: To add an upper limit segment from 1MHz to 1GHz with value 20 dB for
trace 1:
:CALC1:LIM:UPP:SEGM:ADD 1e6,1e9,20,20
Notes: Replace ’#’ with the required trace number. Check User Guide for the
number of supported traces in each mode.
:CALCulate#:LIMit:UPPer:SEGMent:DELete
Cmd Description: Command deletes the active upper segment.
Example: To delete the active upper segment for trace 1
:CALC1:LIM:UPP:SEGM:DEL
Notes: Replace ’#’ with the required trace number. Check User Guide for the
number of supported traces in each mode.

Anritsu Site Master S331L Specifications

General

Brand	Anritsu
Model	Site Master S331L
Category	Measuring Instruments
Language	English