EVDO Signal Analyzer 3-4 EVDO RF Measurements Setup
3GPP2 MG PN: 10580-00235 Rev. D 3-3
MAC Codes Setup
MAC Walsh Codes setup is used to select 64 codes or 128 codes.
1. Press the Setup main menu key.
2. Press the Walsh Codes submenu key to toggle between 64 codes and 128 codes.
3-4 EVDO RF Measurements Setup
To make EVDO RF measurements, connect the instrument to the base station following the
setup instructions. Press the Measurement and RF Measurement submenu keys to open the
measurement menu.
Channel Spectrum Setup
This measurement displays the spectrum of the specified channel and channel power,
occupied bandwidth, and peak-to-average power.
1. Press the RF Measurement submenu key to open the RF Measurement menu.
2. Press Channel Spectrum to display the active measurement (Figure 3-2).
Figure 3-2. EVDO Channel Spectrum
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
