2-11 Sweep Menu Chapter 2 —Fixed WiMAX Signal Analyzer
2-24 PN: 10580-00236 Rev. D WiMAX MG
Pass Fail Mode Menu
Key Sequence: Measurements > Pass/Fail Mode
2-11 Sweep Menu
Key Sequence: Shift > Sweep (3) key
2-12 Measure Menu
This menu open the “Measurements Menu” on page 2-20.
Select Pass/Fail Test: Press this submenu key to display the list of
available Pass/Fail tests.
Reset: Press this submenu key to reset the Pass/Fail test.
Back: Press this submenu key to the “Measurements Menu” on page 2-20.
Figure 2-20. Fixed WiMAX Pass Fail Mode Menu
Sweep Single/Continuous: This submenu key toggles between
continuous sweep and single sweep. In single sweep mode, the results of a
sweep are displayed on the screen while the instrument awaits a trigger
event to start a new sweep.
Trigger Sweep: Pressing this submenu key causes the instrument to make
a single sweep when the instrument is in single sweep mode. This key has
no function when the instrument is in continuous sweep mode.
Figure 2-21. Fixed WiMAX Sweep Menu
Back
Pass Fail Mode
Reset
Select
Pass/Fail
Test
Sweep
Sweep
Continuous Single
Trigger
Sweep
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
