Table of Contents
SM 6495, Rev. 7, December 2008 vii
List of Figures
Figure 1-1 - Model 95 Gate Mechanism Basic Configurations ................................................................
1-2
Figure 1-2 - Original and Redesigned Power Down Modules..................................................................1-4
Figure 1-3 - Model 95 Gate Mechanism Major Installation Parts.............................................................1-5
Figure 2-1 - Completed Pedestrian Crossing Gate Arm Shield Installation.............................................2-5
Figure 2-2 - Wiring Diagram for 12-Volt Systems – with Maintenance Switch ........................................2-9
Figure 2-3 - Wiring Diagram for 12-Volt Systems – without Maintenance Switch .................................2-10
Figure 2-4 - Wiring Diagram for 24-Volt Systems ..................................................................................2-11
Figure 2-5 - Wiring Diagram for 3-Wire Control 12-Volt Systems..........................................................2-12
Figure 2-6 - Wiring Diagram for Pedestrian Mechanism 12-Volt Systems with
Maintenance Switch ..........................................................................................................
2-13
Figure 2-7 - Wiring Diagram for Pedestrian Mechanism 12-Volt Systems without
Maintenance Switch ..........................................................................................................
2-14
Figure 2-8 - Torque Increase/Decrease Diagram ..................................................................................
2-16
Figure 2-9 - Number 1 Contact...............................................................................................................2-18
Figure 3-1 - Hold Clear Device.................................................................................................................3-5
Figure 3-2 - Installation Close-up...........................................................................................................3-10
Figure 3-3 - Location of the Power Down Module (Units Manufactured
Before September 1, 2003)...............................................................................................
3-13
Figure 3-4 - Proper Hardware Configuration on Terminal Posts 1C, 2C, and 3C..................................3-14
Figure 3-5 - Location of Redesigned Power Down Module on Terminal Posts 1C, 2C, and 3C ..........3-14
Figure 5-1 - Model 95 Gate Mechanism – Mechanical Assembly (Sheet 1 of 2)....................................5-4
Figure 5-2 - Model 95 Gate Mechanism – Mechanical Assembly (Sheet 2 of 2)....................................5-5
Figure 5-3 - Model 95 Pedestrian Gate Mechanism – Mechanical Assembly (Sheet 1 of 4) .................5-8
Figure 5-4 - Model 95 Pedestrian Gate Mechanism – Mechanical Assembly (Sheet 2 of 4) .................5-9
Figure 5-5 - Model 95 Pedestrian Gate Mechanism – Mechanical Assembly (Sheet 3 of 4) ................5-10
Figure 5-6 - Model 95 Pedestrian Gate Mechanism – Mechanical Assembly (Sheet 4 of 4) ...............5-11
Figure 5-7 - Model 95 Sidewalk Gate Mechanism – Mechanical Assembly (Sheet 1 of 3)
(RH Shown – LH Available)...............................................................................................
5-14
Figure 5-8 - Model 95 Sidewalk Gate Mechanism – Mechanical Assembly (Sheet 2 of 3)
(RH Shown – LH Available)...............................................................................................
5-15
Figure 5-9 - Model 95 Sidewalk Gate Mechanism – Mechanical Assembly (Sheet 3 of 3)
(RH Shown – LH Available)...............................................................................................
5-16
Figure 5-10 - Model 95 Gate Mechanism Electrical Assembly with PN-150 Relay
(12-Volt Systems)..............................................................................................................
5-19
To Next Page
Loading...