168
Doc.Id. HMSI-27-212
Anybus CompactCom 40 EtherNet/IP
Doc.Rev. 1.5
Extended Error Code
If the Error code equals FFh (Object specific error), the extended code will be translated as below:
See also...
• “Connection Manager (06h)” on page 70 (CIP)
• “Message Segmentation” on page 189
Code Contents CIP no. CIP status code Additional Information
01h Ownership con-
flict
01h Connection failure The configuration data was supplied in a forward open
request.
10h Device State con-
flict
The configuration data was supplied in a set request
to the Assembly object.
02h Invalid configura-
tion
09h Bad attribute data CIP extended error code: Use value from MsgData[2 -
3]. The extended error code shall only be used if the
request originated from a Forward Open request, not
for explicit set requests.
To Next Page
Loading...