52
1 BEEP (00-15)
Beep volume level when a key is pressed or for an error beep. Default is 05.
2 VOL ATT (00-15)
Limits the maximal volume level. 00 is maximum volume, 15 is the most attenuated.
For levels 06and over, [VolATT] is displayed on screen.
Default is 05.
3 CONTRAST (00-40)
Sets the LCD contrast level. Default is 30.
4 BACKLIGHT
Sets the LCD backlight behavior.
OFF (default) Always off. Saves battery power.
CONT Always on. Consumes more battery.
AUTO Switches on when some keys or controls are operated, switches
automatically off after 5 seconds.
5 SQL.SKIP
Related to audio recording behavior.
ON (default) Audio is only recorded when the squelch is open.
OFF Audio is recorded no matter if the squelch is open or closed.
6 RES.CODE
Related to receiver control by PC commands.
ON (default) A result code is added to the beginning of a command response.
OFF Command responses do not feature a result code.
7 PROTECT
Related to configuration auto-store when the receiver is switched off.
ON Configuration auto-store is off.
OFF (default) Configuration auto-store is on.
8 RF-GAIN (000-255)
Manual gain control. Function only active when AGC is set to manual [RF-G]. Can be
useful in SSB or CW to improve signal to noise ratio. Default is 000.
(p2/2 of MENU CONFIG)
4 SYSTEM RESET
All settings are reverted to factory default. Memory data remains.
5 FULL RESET
All settings are reverted to factory default and all memory data is deleted.
6 FACTORY MENU
Access restricted to our servicing department.
To Next Page
Loading...
