DRAFT
September 25, 2007 1:07 am, 4376782_Maintain_the_System.fm
Chapter 6 Maintain the System
Infrequent Maintenance
121
Applied Biosystems StepOne
™
and StepOnePlus
™
Real-Time PCR Systems
Installation, Networking, and Maintenance Guide
Notes
3. Remove the power entry module and fuses from the power entry module:
a. Insert a small flat-tip screwdriver into one of two slots in the right side of the
power entry module containing the fuses, and pry open the door.
b. Insert the screwdriver into either side slot on the fuse compartment and eject
the power entry module.
c. Replace the burnt fuse(s) in the power entry module with a new 10 A fast-
acting 250 VAC fuse.
4. Replace the power entry module:
a. Lightly squeeze both mounted fuses between your thumb and forefinger and
insert the power entry module into the fuse compartment until it is fully seated.
b. Press the power entry module door until it locks in place.
‘
5. Connect the power cord to the back of the instrument.
6. Power on the instrument, then wait for it to perform a diagnostic of all major system
components. If the diagnostic is successful, the instrument displays the main screen.
If the instrument detects a problem, it displays an error code for the related failed
test. Repeat the procedure above without replacing the fuses to reseat the fuse
holder. If the problem persists, contact Applied Biosystems as explained in “How to
Obtain Support” on page x.
To Next Page
Loading...
Need help?
General
