EN-21
Engine System Argo Service Manual
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
8. Reconnect the throttle cable at the engine cable retainer.
9. Reconnect the ground cable at the engine.
10. Reconnect the fuel line and return fuel line from the engine.
11. Locate the tailpipe assembly and reattach to the muffler with connecting springs.
12. Reinstall the heat deflector shield over the muffler.
13. Reconnect the battery positive (+) and negative (-) cables.
IMPORTANT
Reconnect the Positive (+) cable rst, followed by the negative cable.
IMPORTANT
Refer to the diagram for detailed information on the engine mounting hardware.
Removing The Briggs 600 Engine From The Vehicle.
1. Disconnect the battery positive (+) and negative (-) cables from the battery.
2. Remove the heat deflector shield covering the muffler.
3. Locate the tailpipe assembly and detach the connecting springs between the tailpipe
assembly and muffler. Pull the tail pipe assembly out through the hood area.
4.
Disconnect the fuel line and return fuel line from the engine.
To Next Page
Loading...
