CS175-275-575-875 Installation Guide 105
2. The keypad prompts you to enter a module number.
3. Enter the module number and press
#
. The module number is the DIP switch
setting and can be from 32 to 39.
4. Press 199# to select location 199.
5. Press XX
#
where XX is the zone number (1 to 168) and
#
is the entry key.
6. Perform a walktest on the device. PIR detectors transmit only if there has been no
movement within the area for two minutes.
7. When the device has transmitted, you can record the reading from location 200.
Press 200# to get the RSSI reading.
8. Note the RSS reading and repeat steps 4 to 7 for the other detectors.
To Next Page
Loading...
Need help?
General
