42
CS175-275-575-875 Installation Guide
10.2.4 Setting elapsed increments since last autotest
1. Press 95.
2. Enter a Go to program code.
3. Enter a three-digit number and press #.
10.2.5 Setting the system time and date
1. Press 96.
2. Enter a master user code.
3. Use the scroll keys to change the settings.
4. Press between each part of the date and time.
10.2.6 Setting the light control for X-10 devices
1. Press 47. The keypad prompts you to select a light number between 0 and 9.
2. Enter the number of the device you want to edit. The keypad displays the light
number and prompts you to turn the light on or off.
3. Use the scroll keys to turn the device on or off.
4. The keypad prompts you to select a light number between 0 and 9.
5. Repeat steps 2 and 3 until complete.
6. Press
#
to exit.
10.2.7 Setting the unit and house codes for X-10 devices
1. Press
48
.
2. Enter a Go to program code.
3. Enter the unit code and press . The keypad prompts you to enter the house
code.
4. Enter the house code and press . The keypad increments to the next light
number and prompts you to enter the unit code.
5. Repeat steps 2 and 3 until complete.
6. Press # to exit.
10.2.8 Changing user codes
1. Press 5.
2. Enter a master user code. The Ready LED flashes.
3. Enter a two-digit user number, For example, 03 is user 3. The keypad displays the
current code for this user. Stars () represent blanks.
To Next Page
Loading...
Need help?
General
