40
CS175-275-575-875 Installation Guide
10 PROGRAMMING THE SYSTEM
10.1 Enrolling modules and keypads
The CSx75 can automatically find and store in its memory all keypads, zone expanders,
wireless receivers and any other module connected to the data terminal. This allows these
modules to be supervised by the control panel.
Steps
1. Press 8.
2. Enter a Go to program code. The default code is 1278 for a four-digit code or
127800 for a six-digit code.
3. Press the Exit key to leave programming mode. When you leave programming
mode, the CSx75 automatically enrolls the devices. The enrolling process takes
about 12 seconds. User codes are not accepted during this time.
10.2 Programming the LCD keypads
This section describes how to program the address, partition and available options for
each LCD keypad.
10.2.1 Changing the keypad number and partition
You must set the partition and keypad number for the current keypad. The keypad can
connect to the bus only after you set these numbers.
1. Press 94
.
2. Enter a Go to program code.
3. Enter the keypad number (1-8).
4. Press .
5. Enter the partition number. The keypad automatically exits this mode.
10.2.2 Adjusting the view / brightness of the LCD
1. Press 91.
2. Enter a master user code. The LCD prompts you to change the view.
3. Use the scroll keys to raise or lower the text view.
4. To advance to the brightness option, press . The LCD prompts you to change
the LCD lighting.
5. Use the scroll keys to increase or decrease the brightness.
6. When you have finished making changes, press to exit.
10.2.3 Setting keypad options
To Next Page
Loading...
Need help?
General
