CS175-275-575-875 Installation Guide 41
1. Press 93.
2. Enter a Go to program code.
3. Set the keypad features listed in the following table. Press 0
to turn a feature off.
Press
1
to turn a feature on.
4. When you have finished setting the options, press to display the additional
feature selection and then set these features. Press 0
to turn a feature off. Press
1
to turn a feature on.
Keypad Feature Enabled
Case Tamper on?
Reports any keypad tamper.
Silent Keypad?
Silences the entry/exit sounder and chime only.
Ding dong chime?
If off, the chime is a single tone. See
Location 52
on page 71 for more information.
5 sec silence
Silences the pulsing keypad sounder for five
seconds when a key is pressed.
Armed zone info?
Does not allow the keypad to display faulted or
bypassed zones when the system is armed.
Beep on panics?
Sounds a short beep to verify that the keypress is
accepted.
Disable service?
Turns off the service required message.
Master keypad?
Enables temporary viewing of all partitions when
1 is pressed followed by the partition number.
Custom message?
Uses the custom message. See
Programming
custom messages
on page 44 for information.
Clock?
Displays the date and time.
Custom message lock?
Locks the custom message. See
Programming
custom messages
on page 44 for more
information.
Additional Keypad Features
Option 1
Displays the menu. Press for help.
Option 2
Disables LED extinguish on this keypad.
Option 3
On hides the PIN when programming.
Option 4
On suppresses beeps when an RF transmission is
lost.
Option 5-8
Reserved
To Next Page
Loading...
Need help?
General
