CS175-275-575-875 Installation Guide 97
Repeater
Press and then release the tamper switch.
16.4.4 Deleting transmitters
The following steps describe how to delete transmitters from the module.
The module ignores a transmitter but does not remove its identification from the module’s
memory. The transmitter can be reactivated later or a new one can be learned into the
zone.
Steps
1. Press 8 to enter programming mode.
2. Enter a Go to Program Code. The keypad prompts you to enter a module number.
3. Enter the module number and press #. The module number is iis the DIP switch
setting, for example 35,36,38 or 39.
4. Press XX# where XX is the zone number (1 to 168) and where # is the entry key.
5. Press 1 to change the transmitter feature 1 (Transmitter Enabled). The first bit in
the segment changes from ‘1’ to ‘-, to indicate that the wireless component is
disabled.
6. Repeat steps 4 to 5 until all transmitters are deleted.
7. Press the Exit key twice to exit programming mode.
16.4.5 Testing wireless transmitters
Use the walktest to test the wireless transmitters.
To Next Page
Loading...
Need help?
General
