Aritech CS875 User Manual

CS175-275-575-875 Installation Guide 53
12.5 Defining the country code
1. Enter programming mode as described in
Entering programming mode
on page
54.
2. Press 0# for the controller.
3. Press 0# for the first location in the controller.
4. Enter the country code and press

. When this location is changed from the
keypad, the panel returns to the default country settings.
12.6 Programming via the LED keypad
12.6.1 Entering programming mode
1. Press 
8
.
2. Enter a Go to program code.
3. The Service LED blinks, prompting you to enter a module number.
4. Enter the module number and press #.
5. The Armed LED lights, prompting you to enter a programming location.
6. Enter the location number and press #. If the location is valid, the Armed LED
turns off, the Ready LED lights up and the binary data for the first segment of the
location is shown by the zone LEDs. While you are entering new data, the Ready
LED flashes to indicate that a data change is in process. The flashing continues
until the new data is stored.
7. Press  to save any changes you have made. The keypad displays the data in
the next segment.
8. Repeat steps 4 to 7 until the last segment is reached.
9. Press # to exit the location.
10. The Armed LED lights up, prompting you to enter a new programming location.
"
You cannot enter programming mode if the system or any partition is armed. The timeout
for programming mode is 15 minutes.
12.6.2 Exiting a location
•
When you have programmed the last segment of a location, press  to exit the
location and save the data. The Ready LED turns off.
•
To exit before the last segment, press #. Any changes you have made are not saved.
You can then enter another programming location.
12.6.3 Exiting programming mode
•
Press the Exit key to leave the current programming level.
•
If you do not want to program additional modules, press the Exit key again to exit
programming mode.

Aritech CS875 Specifications

General

Brand	Aritech
Model	CS875
Category	Security System
Language	English