Safety Instructions 24
CAUTION
Connected cable on the floor
Risk of injury caused by tripping, falling or slipping over connected cables.
Always properly secure cables connected to the TRINITY 2.
Install cables in a way that they cannot be tripped over.
If necessary, use a cable duct or secure the cables with adhesive tape.
Disconnect the cables from the TRINITY 2 before moving.
CAUTION
Unhealthy posture or excessive physical exertion during operation
Improper handling of the TRINITY 2 can lead to permanent physical injuries to the human
locomotive system.
Ensure an ergonomic posture when operating and carrying the TRINITY 2.
CAUTION
Radio radiation caused by external radio accessories
May cause physical impairments such as sleep disturbances and stress.
Follow the manufacturer's instructions.
Use only TRINITY 2 components approved by ARRI. The use of components not approved by
ARRI is at your own risk. Please observe all relevant safety guidelines
ADVICE
Powering TRINITY 2 Head, Top and Bottom Stage at the same time
This would cause more than the allowed amount of volts to flow through the ARTEMIS 2
and TRINITY 2. Risk of damage to the accessories.
Only use the Top Stage TST-2 in combination with the Battery Hanger Module BHM-2 for the
internal power supply of the TRINITY 2 Head.
Alternatively, an external power source can be used to power the TRINITY 2 head.
DO NOT combine the internal with an external power supply!
To Next Page
Loading...
