13
2. Enter – Strip length (typical both ends) (See page 16)
3. Enter - Strip pull length (values the same or larger then Strip Length will remove the strip. Values smaller
will leave the strip on by the differential) (See page 16)
4. Enter - Blade opening distance corresponds with approximate conductor diameter. (See page 18)
5. Wire: This will open the Wire Properties window where the wire characteristics are set up (see page 22)
6. Drop down menu to select previous qualified wires. Selection will be displayed in adjacent window.
7. Mode: Allows selection of Auto, Single, or Step modes of operation. (see page18)
8. This allows the control of the global speed of the machine in the selected mode. (5 to 100%)
9. This selects the stripping method: Short mode, Center Stripping, and Double Strip.
10. Total Parts/ / Programmed: Enter – Total number of parts desired. (See page 18)
11. Batch Parts/ / Programmed: Enter – Number of parts desired in a batch. (See page 18)
12. Click on Ruler Icon to switch between Inch and Metric measuring mode.
13. Click on the Wire Icon to set up or modify the part properties.(see page 19)
14. Drop down menu to select previous programmed parts. Selection will be displayed in adjacent
window.
15. Click on the Wire Array Icon to set up or modify the Job properties.(see page 27)
16. Drop down menu to select previous programmed Jobs.
17. Click on the Folder Icon to set up or modify data folders.(see page 30)
18. Drop down menu to select previous established folders. Selection will be displayed in adjacent
window.
19. Operator instructions programmed with the part.
20. Shows current and real time production rates.
21. Saves all changes made to current programs.
22. Opens
Maintenance I/O statues screen (Including machine states, I/O data, and servo data)
23. Opens the Machine Configuration Window. (See page46)
24. Preprocess-Marking / Slitting ### indicates a preprocess is selected (see page 64)
To Next Page
Loading...
