39
7. Turn on Library mode.
To activate or deactivate Library mode.
From the main menu select – Maintenance – Data Organizer
Select library. When it is checked it is active. When it is not checked it is not active.
Using a common folder on a network drive.
It is possible to run several machines from a common network folder. The parameters that are machine
specific are part of the wire properties, these include the strip diameter and length calibration.
Using library mode as described above will allow you to make these machine specific changes and have
common part and job data. The trade off when using library mode is that new wires must be added
individually to each machine.
MAIN MENU SELECTIONS
File
Save folders – Save current work. This is the same as clicking the disk icon to save your work.
Reload Current Folder – Restore the folder to the last saved condition. This is useful if you made some
changes that you know you don’t want to save.
Export – Export the part, if a job is active it will export the job and the part. See section “Data Export”
Export Current Folder – Export, all the data in the current folder. See section “Data Export”
Import – Import data from an .XML file. This can any combination of wires, pre-processes, parts or
jobs.
Import old CS326 folder – N/A
Backup – This saves all the CS326 parts, jobs, and machine configuration data to a single zipped file.
See section “Data Backup”
Restore – This restores all the CS326 parts, jobs, and machine configuration data to a single zipped file.
See section “Data Restore”
Restore from old backup – If the backup to be restored was made in a very old version of the CS326
software, the backup will consist of a group of directories rather than a single zipped file. This
function if for this type of backup.
Recover Folder Data- Not currently implemented.
To Next Page
Loading...
