92
Step 2 Mechanical setup
Refer to the pictures on previous page.
To change the pinch blades (“C”) loosen the “Cutoff Blade Clamping Screws” (marked “D”). at least one
full turn These screws can be accessed with the cut blades fully extended or full retracted. Support the
upper blade so it does not drop out. Cut blades must be fully retracted and the cutterhead full open to
remove the blades. Install the new blades with the proper cutting edge relationship. The upper cutting
edge faces to the right and the lower faces to the left. Tighten the “Cutoff Blade Clamping Screws”.
Manually close the cutterhead and insure the blades bypass freely with the cutting edges in contact with
each other.
PINCH BLADE CALIBRATION
1. Have the pinch blades installed in the machine.
2. Click maintenance then click machine settings.
3. Manually rotate the cut off blade cylinder so the blades are fully extended.
4. Manually close the cutterhead so the blades are seated tightly against each
other.
To Next Page
Loading...
