Artos CS-327 - CONFIGURATION; Programming Machine Options

46
CONFIGURATION
Configuration is used to configure the CS 327 with its options. As well as set-up associated position
ands timing values.
Click on the wrench symbol to open the tabbed menu:
ProgrammingMachineOptions
The General tab is information about the basic unit;
 Blade type selection for configuring the type of blade holder mounted on the machine.
o Double has separate pairs of cut off and stripping blades
o Multi-blade has 3 or more pairs of blades 1 pair of cut off and seprate stripping blades
for each end of the wire.
o Pinch is a blade design works like a standard side cutter. The main use for this type of
blade is to cut brake line housing.
 Feed encoder installed is not used. Checking or not checking this box will have no effect on
the machine
 Wire feed using wheels is not used. Checking or not checking this box will have no effect on
the machine