63
CD-16 3 meter Motorized Linear Collector.
5-143855 Internal CS327 cable
The out feed guide is removed from the CS327 and
the CD-16 guide is positioned in its place to receive
the wire from the outfeed system.
The first cut (justification piece) should be short. It is
recommended to set the “Lead dress length” in the
General Configuration to minimum .5 so the cut off
piece drops in the scrap tray.
CD-17 Dual Bowl Collection System,
available in 18 inch (457mm), 24 inch
(610mm) or 30 inch (762mm) diameter
bowls for collecting long wires. The
system consists of two rotating
collectors (bowls). These bowls are
filled alternately. One is filling while
the other is stopped to be emptied. The
amount of time allowed to empty the
stationary bowl is controlled by the
“Feed Delay” setting in the Post
Process Configuration.
To Next Page
Loading...
