74
Continuous Marking This will apply the same
mark to both ends of the wire, spaced from the
ends as programmed. It will also place marks
along the length spaced according to the value
set in the center window. This mode causes the
machine to produce less parts per hour as
compared to Continuous marking (simple)
Continuous Marking (Simple) This will apply
the same mark along the length of the wire
starting from the leading end at the distance
programmed. The spacing between the marks is
determined by the distance programmed in the
center window.
Single Label This will apply the mark to the
leading end of the wire,
To Next Page
Loading...
