ARxIUM FastPak EXP - Removing and Installing the Lower Assemblies

Removing and Installing the Lower Assemblies
8 FastPak EXP Operating Manual
The printing and packaging assemblies, located in the bottom
portion of the cabinet, roll out for easy access.
Figure 1-4 Inside lower cabinet
Removing and Installing the Lower Assemblies
The entire printing and packaging assembly,
sometimes called the lower packaging unit (LPU),
may be removed if you want to replace the current
assembly with the alternate assembly. For example, if
you are dispensing the 60 mm unit-dose pouches, and
want to package the 80 mm multi-dose pouches, you
must change the lower assembly.
Packaging
material
shutter
Lower/Second
Cutter
Conveyor
Ribbon
(inside box)
Heat seal
assembly