ARxIUM FastPak EXP - Connecting FastPak EXP to ARxIUM Computer

Connecting the FastPak EXP to the ARxIUM Computer
16 FastPak EXP Operating Manual
Connecting the FastPak EXP to the ARxIUM Computer
Connect the FastPak EXP to the ARxIUM computer
as follows:
1. Locate the 9-pin-to-9-pin RS-232 serial cable
provided with the device.
2. Plug one end of the cable into the communica-
tion port on the back of the FastPak EXP.
3. Plug the other end of the cable into COM 1 of the
ARxIUM computer.
Installing the Touchscreen
Follow the steps below to mount the touchscreen on
the side of the FastPak EXP.
1. Identify where you wish to install the
touchscreen - on the left or right side of the
device cabinet.