ARxIUM FastPak EXP - Page 60

Replacing the Cutter Blade
48 FastPak EXP Operating Manual
To change the cutter blade, do the following:
1. Turn off the power to the FastPak EXP.
2. Open the front door, locate the cutter blade
assembly, and remove the blade guide by lifting
it off the cutter blade assembly.
Figure 5-6 Cutter blade and perforation blade
assemblies
3. Remove the cutter blade assembly by lifting its
right side slightly out of the guide hole and
sliding the assembly to the right, removing it
from the key way.
Cutter blade
assembly
Perforation
blade
assembly
CAUTION!
HIGH
TEMPERATURE