SECTION 3 OPERATING THE A-2000
______________________________________________________________________
3-28
3.7 ENDING A CASE
When the case has finished:
• Disconnect the patient sensor from the PIC:
Standard system: Grasp the connectors firmly and pull. DO NOT pull apart by
the cable wires.
BIS XP Platform/ XP Compatible: Press the release button on the connector
and pull the connectors apart. DO NOT pull apart by the cable wires.
• Remove BIS Sensor from patient.
• Be sure to leave the PIC with the monitor so that it is not inadvertently discarded.
• If this is the last procedure of the day, press the button on the right side of the
monitor to turn the power OFF.
WARNING!
SHOCK HAZARD: DO NOT ATTEMPT TO DISCONNECT THE
POWER CORD WITH WET HANDS. MAKE CERTAIN THAT YOUR
HANDS ARE CLEAN AND DRY BEFORE TOUCHING THE POWER
CORD.
3.8 DATA TRANSFER
BIS values and other EEG data may be acquired from the monitor using the RS-232
serial port. Please contact Aspect Medical Systems for instructions. (See back cover for
contact information.)
To Next Page
Loading...