SECTION 4 QUICK REFERENCE GUIDE
______________________________________________________________________
4-2
If you want to: Do this:
• Mark an event
• Initiate a sensor check
• Change the display type
• Change the BIS Smoothing Rate
• Access the Advanced Setup Menu
• Press [MENU/EXIT] from the Main
Screen to get to the Setup Menu.
• Use the arrows to highlight your choice.
• Press [SELECT].
• Change the secondary variable
• Adjust the time or date
• Print data from an event
• Display the Parameter Setup
• Access the Diagnostic Menu
• Access the Alarm Menu
• Access the Language Selection Menu
• Save settings
• Press [MENU/EXIT] from the Main
Screen to get to the Setup Menu, then
select Advanced Setup Menu.
• Use the arrows to highlight your choice.
• Press [SELECT].
• Display a second channel of EEG (BIS
Quatro and BIS Extend sensors only)
• Turn the EEG filters OFF
• Change the EEG sweep speed
• Change the EEG amplitude
• Change the default BIS Log interval
• Press [MENU/EXIT] from the Main
Screen to get to the Setup Menu, then
select Advanced Menu.
• From the Advanced Menu, select
Display Parameter Setup.
• Use the arrows to highlight your choice
• Press [SELECT].
• Test the DSC
• Test the screen display
• View sensor data
• Clear data
• Display diagnostic codes
• Disable continuous impedance check
• Access the System Configuration Menu
• Find the software revision number,
serial number, or other data
• Press [MENU/EXIT] from the Main
Screen to get to the Setup Menu, then
select Advanced Setup Menu.
• From the Advanced Setup Menu, select
the Diagnostic Menu.
• Use the arrows to highlight your choice
• Press [SELECT].
• Set BIS limit alarms
• Change the Alarm Silence button to
suspend alarm silence after 2 minutes.
• Press [MENU/EXIT] from the Main
Screen to get to the Setup Menu, then
select Advanced Setup Menu.
• From the Advanced Setup Menu, select
the Alarm Menu.
• Use the arrows to highlight your choice
• Press [SELECT].
To Next Page
Loading...