IDA8 Global-Net User Manual360
© 2017, ATEÏS, member of PAX ProAV Group
3. The [Connection] block in red shows which device has been connected and the block at the right
shows the function settings users can configure such as Update Firmware, Download Config etc..
4. Now Drag n Drop the device/system into the configuration window, there will be a [Set Audio
Module] window appears. See the picture below,
4.4.2 Deploy
The Deploy function allows to configure the networking state of devices on Ateis-Net. Connecting the
physical units together through ATEIS Global-net port and the identification must be assigned to each
device when they are setup for the first time. To do this, you need to configure the "config IP" function
by following the steps listed below:
1. Open [Device Management] window.
2. Search and connect to the device.
3. Select the device on the Device List and click [Deploy] button.
4. After a pop-up window appears, click [...] Deploy button to start deploying.
4.4.3 Front Panel Language
For Ateis Studio Version 2.0.X
Allow to modify the texts on front panel display to customized languages.
Step 1:
1. Open [Device Management] window.
2. Search and connect to the device.
3. Click [Front Panel Language] button.
Step 2:
To Next Page
Loading...
Need help?
General
