Recommendations for electrical
testing intruments
RelAX6000-U/0940
Precautions on the test environment
Let the test area dry and clean, free from explosive gas.
Precautions on the operators
ATEQ recommends that the operators using the instruments should have a suitable
qualification and training with respect to the work bench requirements.
General precautions
Read the users manual before using the instrument,
all electrical connections coming to the instrument must be equipped with a safety
system (fuse, circuit breaker…) adapted to the needs and adhering to the norms,
to avoid electromagnetic interference, the cable connections to the instrument
should be less than two meters in length,
the electrical main supply must absolutely have proper connection to the earth,
disconnect the electrical connections to the equipment for maintenance,
do not open the instrument under power voltage,
avoid water spillage in the direction of the instrument,
ATEQ is at your disposal for any further information concerning the use of the
instrument under maximum safety conditions.
!
We would like to bring to your attention that ATEQ will not be held
responsible for any accident connected to the improper use of the
instrument, to the work bench or to the lack of compliance with safety
rules.
ATEQ Company is free from any responsibility for any adjustment of
its instrument which would not have been done by its own
technicians.
To Next Page
Loading...
Need help?
General
