FlexiROC T35 R/T40 R 5 Controls
49 No: 3171473547.1 en
Symbol Description Symbol Description
Engine service
Indicates time for en-
gine service according
to preselected number
of hours
Rock drill service
Indicates time for rock
drill service according to
preselected number of
hours
Communication fault
Indicates disrupted
communication in the
CAN BUS system.
Length Sensor
Indicates that the length
sensor is not calibrated
Battery
Indicates that the
voltage from the battery
is less than 24V
Compressor air filter
Indicates that the com-
pressor air filter is
clogged
ECL collection
Indicates that the ECL
collection is too low or
too high
ECM
Indicates an ECM error
Engine temperature
The engine temperature
is becoming too high
Engine air filter
Indicates that the en-
gine air filter is clogged
Engine reduction
Indicates that a fault
has arisen and the en-
gine output is limited
Intake temperature
Indicates that the intake
temperature in the en-
gine is too high
Fuel level
Indicates low fuel level
Fuel temperature
Indicates that the en-
gine's fuel temperature
is too high
Fuel pressure
Indicates that the fuel
injection pressure is ab-
normal
Engine oil pressure
Indicates that the oil
pressure to the engine
is becoming too low
Drill bit
Indicates that replace-
ment is due
Boom articulation
sensor
D170 Sensor error
Angle sensors
D171 Sensor error
Length Sensor
D172 Sensor error
High exhaust temper-
ature (HEST-)
High soot content in
the particulate filter
(DPF)
To Next Page
Loading...
Need help?
General
