FlexiROC T35 R/T40 R 5 Controls
63 No: 3171473547.1 en
Pos. Function
a Selection of drilled length measurement
method: Mark the box using the arrow keys and
confirm with Enter. Select hole depth gauge or
vertical depth gauge using the arrow keys and
confirm with Enter.
For further information, see the chapter on "Oper-
ating the drilled length instrument".
b Service interval, engine hours: Shows the
number of hours left before the engine requires
servicing.
When the preset number of engine hours has
been reached, the "engine service" symbol will be
shown in the status bar of the display.
When service has been carried out the new set-
ting is added:
n Use the arrow keys to move to and mark the
box. Confirm your selection with Enter.
n The digits will then be highlighted in blue and
show the preset service interval instead of the
remaining hours.
n Use the arrow keys to change the preset ser-
vice interval and confirm with Enter.
n The digits will now indicate the remaining
number of hours until the engine requires ser-
vicing.
c Service interval, percussion hours: Shows
the number of hours left before the rock drill re-
quires servicing.
When the preset number of engine hours has
been reached, the "service rock drill" symbol will
be shown in the status field of the display.
When service has been carried out, add the new
setting
n Use the arrow keys to move to and mark the
box. Confirm your selection with Enter.
n The digits will then be highlighted in blue and
show the preset service interval instead of the
remaining hours.
n Use the arrow keys to change the preset ser-
vice interval and confirm with Enter.
n The digits will now indicate the remaining
number of hours until the rock drill requires
servicing.
d Drill bit grinding interval, drilled length: Dis-
plays interval set in number of drill-metres for re-
placement or grinding of drill bit.
To Next Page
Loading...
Need help?
General
