Audi A6 2005 - Page 75

– ... then press on housing retaining spring at the bottom and at
the same time press in pad retaining spring, as indicated by
-arrows-.
– Check that housing retaining spring is engaged correctly on
pad retaining spring and that top and bottom ends of housing
retaining spring are engaged correctly in brake carrier.
– Attach brake line
– Connect wear indicator connector and insert wire in dust cap
and protective cap.
– Fit wheels ⇒ Wheels and tyres; Rep. gr. 44 .
Note
♦ The retaining spring must be pushed under the brake carrier
after engaging onto both studs. If incorrectly installed, the wear
of the outer pad cannot be adjusted, and the pedal travel will
be increased as a result.
♦ After installing the brake pads, depress the pedal firmly sev‐
eral times with the vehicle stationary, so that the pads are
properly seated in their normal operating position.
– Check brake fluid level and top up if necessary.
Caution
Make sure that the brakes work properly before the vehicle is
driven on the road.
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
2. Front brakes FNR G60 (PR 1LG/1LD/1LH/1LV/1ZL) 69