Audio Precision ATS-1 Access - Page 159

Setup Panel 3-10, 4-46
Setups, saving and recalling 4-51
SINAD function 4-22 - 4-24
SLOW (sweep speed) 4-44
SMPTE standard (IMD) 4-27
Speaker monitor 3-6
Holding range 4-41
Specifications D-1 - D-8
Starting sweeps 4-45
Stereo balance measurement 4-29
Stereo separation measurement 4-34
Stopping sweeps 4-45
Supply voltage indicators 2-1
Swapping Connector Panel and Loudspeaker
C-3 - C-5
Sweep cursors 4-45
SWEEP key 3-9, 4-42, 4-45
Sweep panel 3-9, 4-42 - 4-45
Sweep speed, tape recorder testing 5-3
Sweeping 4-42 - 4-45
Symbols available for setup names 4-53
T
Table printouts 4-48
Sample 4-49
Tape recorder alignment 5-2
Tape recorder azimuth adjustments 5-2 - 5-3
Tape recorder bias adjustments 5-4
Tape recorder EQ adjustments 5-2
Tape recorder inter-head delay 5-3
Tape recorder measurements 5-2
Terminations 3-29
THD+N
At 100% 4-19
Changes with amplitude 4-18
Changes with frequency 4-17
Isolating sources 4-20
Selecting bandwidth 4-14
Understanding 4-11
What is signal dominant? 4-13
THD+N Function 4-7 - 4-10
Third harmonic distortion measurements 5-4
Time units 3-22
Time, setting 3-10
Times-10 key 3-2
Transmission link testing 5-1
Trigger Outputs 3-25
U
UN-WTD (Unweighted) 4-2, 4-9, 4-33
UNBAL (Unbalanced configuration) 3-29
Unbalanced vs balanced 2-3
Units
Amplitude units 3-17 - 3-23
Using cursors 4-45
V
V (Volts) unit 3-18
Version of internal programs 2-5
Version of internal programs 2-5 1-9
Voice announcements
reference tape 5-2
Voltage gain or loss measurement 4-29
Vp unit 3-18
W
W (Watts) unit 3-21
W+F Function 4-31
Waveform shape 4-34 - 4-35
Analog 3-13
Wow and Flutter Measurement 4-31
Write-protecting setups 4-51
WTD (weighted) 4-3, 4-10, 4-33
X
X/Y unit 3-18
XTALK (Crosstalk) Function 4-34 - 4-35
Index
Index
Portable One Plus Access User's Manual Index-5