Audio Precision ATS-1 Access User Manual

Identification of Features and Options
IMD Option
The IMD (Intermodulation Distortion) measurement function is
available only if the IMD option has been installed. If present, this
option will be marked on the Options label on the rear panel (see page
1-9). If not present, the front-panel IMD button will have no effect.
Connector Panel Options
The connector panel normally shipped with the ATS-1 Access has
BNC connectors and banana jacks for the generator outputs and
analyzer inputs and is mounted on the front. This is the configuration
shown in the figures in this manual. Alternatively, the connector panel
may be mounted on the rear, and the speaker panel mounted on the
front.
Other connector panel options are available, and may be ordered with
the instrument or installed later by the user. Connector panel options
are:
.
3-pin XLR and banana jack connectors
.
WE-310 tip-ring-sleeve and banana jack connectors
.
1/4-inch phone and banana jack connectors
To install connector panel options or to swap the connector and
speaker panels, refer to Appendix C.
Optional Filters
In addition to the built-in filters, the ATS-1 provides two positions for
optional filters that can be installed in the field. Refer to Appendix C for
cautions and installation procedure.
1 Description
Identification of Features and Options Description
1-8 ATS-1 Access User's Manual

Audio Precision ATS-1 Access Specifications

General

Brand	Audio Precision
Model	ATS-1 Access
Category	Test Equipment
Language	English