accumulates the errors from one reading cycle to the next, giving the
total number of errors since the totalize operation began. The totalize
display shows the letter T to the right of the reading. To reset the
total, go to real-time display for a moment and then return to totalize.
The upper center section of the display shows the number of data
errors on channel B. This functions in the same way as the channel A
display.
The upper right section of the display shows the current data on one
of the channels. The INPUT A button is used to select the A channel.
The INPUT B button is used to select the B channel. A second press
on either button selects the internal gen-mon path. The upper right
soft key selects whether the data display is shown in decimal or
hexadecimal (base-16) number format. Hexadecimal display is
marked with the word ‘hex’ after the number.
The lower section of the display can show two different binary
displays of the data, selectable by the lower right soft key. The
following are available:
.
ACTIVEBIT – Shows which bits are changing state
.
ACTUALBIT – Shows the actual value of each bit
4 Functions
Data Check Function Descriptions
4-46 ATS-1 Dual Domain User's Manual
To Next Page
Loading...
Need help?
General
