Setup 3-10, 4-57
Sweep 3-9
Parity flag 4-49
PASS waveform 3-16
PCL GRAPH (printer setting) 4-57
PEAK 4-32
Phase function 4-23 - 4-25
Phase measurement channel selection 4-24
Phase units 3-32
Power line monitoring 4-35 - 4-36
Power switch 2-1
Power units 3-30
ppm unit 3-26, 3-32
Pre-emphasis bit 3-21, 4-48
PRINT key 3-9, 4-58
Print panel 3-9, 4-59
Print samples
High resolution 4-60
Screen dump 4-59
Table sweep 4-60
Printer configuration 3-10
Printer port 3-39
Printing 4-57 - 4-61
Speed 4-60
Priority of digital input selection 3-43
Professional mode 3-20, 4-48
Program version 2-5
R
Rackmounting B-1 - B-4
RAND waveform 3-16
Ratio function 4-28 - 4-29
RCV CLOCK 3-37
RCV ERROR 3-37
RCV FRAME 3-37
Reading Monitor output 3-38
Real-time clock 3-10
Rear panel overview 3-35
RECALL/SAVE Key 3-4, 4-62 - 4-63
Recall/Save panel 3-4, 4-62
Recalling and Saving Setups 4-62 - 4-63
REF BLOCK (delay reference) 4-44
REF FRAME 3-37
REF FRAME (delay reference) 4-44
Reference input 3-36
Unbalanced connection 3-36
Reference tape
frequency response 5-2
Repeating (continuous) sweeps 4-56
Response, tape recorder 5-2
S
s unit 3-26, 3-31
Safety information 1-vii
Sample rate bits 3-21
Save panel 4-63
Saving and recalling setups 4-62 - 4-63
Screen dump 3-9, 4-57 - 4-58
Sample 4-59
Screen saver 3-11
sec unit 3-26, 3-31
Selecting waveforms
Analog 3-15
Digital 3-16
SELECTIVE 4-2, 4-10
Self test
Printing 2-6
Serial number 3-35
Setting the clock 3-10
Setting up 2-1 - 2-7
Setup Panel 3-10, 4-57
Setups, saving and recalling 4-62 - 4-63
SINAD function 4-21 - 4-22
SLOW (sweep speed) 4-55
smp unit 3-26, 3-32
SMPTE standard (IMD) 4-26
Index
Index
ATS-1 Dual Domain User's Manual Index-5
To Next Page
Loading...
Need help?
General
