AudioCodes 445HD - Configuring Message Waiting Indication; Table 5-40: MWI Parameters

400HD Series IP Phones
Administrator's Manual 106 Document #: LTRT-11973
5.8.9 Configuring Message Waiting Indication
The Message Waiting Indication (MWI) feature can be configured.
 To configure MWI:
• Use the table as reference.
Table 5-40: MWI Parameters
Parameter Description
voip/services/msg_waiting_ind/voice_mail_number
Defines the extension number for accessing
your voice mail messages.
 The valid value is up to 64 characters.
voip/services/msg_waiting_ind/enabled Enables the MWI feature.
 0 Disable
 1 Enable (default)
voip/services/msg_waiting_ind/subscribe
Determines whether the phone registers to
an MWI server.
 0 Disable (default)
 1 Enable
voip/services/msg_waiting_ind/subscribe_address
The IP address or host name of the MWI
server. Default: 0.0.0.0
voip/services/msg_waiting_ind/subscribe_port The port number of the MWI server.
Range: 1024-65535. Default: 5060.
voip/services/msg_waiting_ind/expiraition_timeout
The interval between the MWI Subscribe
messages.
Range:0-86400. Default: 3600
voip/services/msg_waiting_ind/always_send_port
If the SIP port is the default port (i.e. 5060),
then remove it from the Request-URI of the
MWI SUBSCRIBE.
 0 Disable
 1 Enable (default)