AudioCodes 445HD - 8.10 Muting Your Speaker, Handset or Headset

Administrator's Manual 5. Configuring VoIP Settings
Version 3.4.3 99 400HD Series IP Phones
5.8 Configuring Supplementary Services
Network administrators can configure various supplementary services supported by the
phone such as Call Waiting, Call Forwarding, Three-way Conferencing, and Message
Waiting Indication (MWI).
5.8.1 Selecting the Application Server
By default, the phone is set for a generic application server. However, you can select a
specific third-party application server as described below.
Note: Configuration of specific supplementary services depends on the third-party
application server used in your organization.
 To select the application server:
• Use the table as reference.
Table 5-32: General Supplementary Services Parameters
Parameter Description
voip/services/application_server_type
Defines the type of the application server to
which the device is registered.
 Generic Generic (default)
 Asterisk Asterisk
 3CX application server
 FreeSWITCH FreeSWITCH
 GENBAND Kandy Business Solutions
softswitch solution
 BSFT BroadSoft (support pending)
 Coral Coral (support pending)
 Metaswitch Metaswitch (support pending)
Note:
 Parameters unique to the selected application
server become applicable in addition to this
page's parameters.
 For more information about Genband KBS
environment, see the Kandy Business
Solutions Feature Description Guide.
system/current_user_presence_status/enabled
Only displayed if the application server selected
[FreeSWITCH] supports it. Enables the presence
feature. The DND softkey on the phone is
replaced by Status; the phone shows and
publishes the presence status.
system/feature_key_synchronization/enabled
Applies only to the BroadSoft application server.
See Section 6.5 for more information.