400HD Series IP Phones
Administrator's Manual 116 Document #: LTRT-11973
5.8.22 Configuring Call Transfer
The network administrator can configure a softkey with attended and blind call transfer
functionality.
To configure a softkey with attended / blind call transfer functionality:
Use the table as reference:
Table 5-53: Configuring a Softkey with Attended and Blind Call Transfer Functionality
Parameter Description
personal_settings/soft_keys/ongoing_call/0/ke
y_function
Default: BLIND_TRANSFER. A softkey with blind
transfer functionality will be displayed in the
phone screen:
Change the default to TRANSFER to configure
the softkey with attended transfer functionality.
5.8.22.1 Configuring the TRANSFER Key to Perform Consultative Transfer
The phone's hard TRANSFER key by default performs blind transfer but you can change the
default for the key to perform consultative transfer.
You need to reconfigure the parameter 'voip/signalling/sip/hk_blind_transfer/enable' as
shown in this section.
To change the TRANSFER key functionality:
• Use the table below as reference, and then click Submit.
Table 5-54: Changing TRANSFER Key Functionality
Parameter Description
voip/signalling/sip/hk_blind_transfer/enable
[Not applicable to 405HD] Changes the hard
TRANSFER key's functionality from
performing blind transfer (default) to
performing consultative transfer.
0 TRANSFER hard key performs
Consultative Transfer
1 TRANSFER hard key performs Blind
Transfer (default)
To Next Page
Loading...
