AudioCodes 445HD - Configuring General Dialing Parameters; Table 5-12: Dialing Parameters

400HD Series IP Phones
Administrator's Manual 76 Document #: LTRT-11973
5.3.1 Configuring General Dialing Parameters
Network administrators can configure general dialing parameters.
 To configure general dialing parameters:
• Use the table as reference.
Table 5-12: Dialing Parameters
Parameter Description
voip/dialing/timeout
The duration (in seconds) of allowed inactivity
between dialled digits. When you work with a proxy,
the number you have dialled before the dialing
process has timed out is sent to the proxy as the user
ID to be called. This is useful for calling a remote party
without creating a speed dial entry (assuming the
remote party is registered with the proxy). Range is 0
to 10. Default = 5.
voip/dialing/interdigit_short_timeout
Shorter than 'Dialing Timeout' (see above). Default: 3
seconds. Implemented as 0S for the Dial Map. If a
user wants to make an international call by dialing 00
and wants to dial the secretary/operator by dialing 0,
the user can do both by adding 0S to the Dial Map.
For example, if the digit map string= *xx|2-9]11|0S|2-
9]xxxxxxxxx|1xxx2-9]xxxxxx, it has 0S in it. When the
user dials 0, 0 will match 0S and will therefore start
the 'Interdigit Short Timeout' timer. After this timeout, 0
is dialed out. User can dial 00 or 0123 within the
'Interdigit Short Timeout'. After the 'Dialing Timeout',
the string is dialed out.
voip/dialing/phone_number_max_size
The maximum length of shortcut numbers that you
can enter and the maximum number of digits that you
can dial
Range is 3 to 32. Default = 32.
voip/dialing/dial_complete_key/enabled
Enables the feature for defining a key to indicate that
dialing has completed. Pressing the Dialing Complete
key (defined below) forces the phone to make a call to
the dialled digits even if there is no match in the dial
plan or digit map.
 0 Disable
 1 Enable (default)
 Note: This parameter is available only if the
parameter 'voip/dialing/dial_complete_key/enabled'
is set to 1.
voip/dialing/dial_complete_key/key
Defines the Dialing Complete key. The valid value is a
single character. The default value is the pound (#)
key.
voip/dialing/unanswered_call_timeout
Timeout before the phone automatically sends a
Cancel message. When the phone makes a call and
the other side doesn't answer, the phone sends a
Cancel after this timeout. Range: 1 to 300. Default =
60.