AudioCodes 445HD - Page 190

400HD Series IP Phones
Administrator's Manual 190 Document #: LTRT-11973
2. On the Shared Call Appearance page shown in the figure above, click Add to configure
an 'Identity/Device Profile Type', and then Use the table as reference to configure the
parameters.
Table A-4: BroadSoft Server - Shared Call Appearance – Identity/Device Profile Type
Parameter Description
Alert all appearances for Click-to-Dial calls
See BroadSoft's documentation for detailed
information.
Select this option when you want your Click-To-
Dial calls to ring all phones that have your line
appearance.
Clear the option if you prefer your line to ring your
phone only.
Alert all appearances for Group Paging calls
See BroadSoft's documentation for detailed
information.
Allow call retrieve from another location
See BroadSoft's documentation for detailed
information.
Select this option when you use a feature access
code to automatically retrieve a call that was
answered at another Shared Call Appearance of
your number.
Multiple Call Arrangement
See BroadSoft's documentation for detailed
information.
Select On
to allow multiple calls using your phone
number / ID to be dialed or answered
simultaneously across all Shared Call
Appearances of your number.
Select Allow bridging between locations when
you want to use a feature access code to bridge a
3-way conference call automatically for any call
that has been answered at another Shared Call
Appearance of your number.
Select Enable Call Park notification for the
phone to alert the user visually and audially when
a parked call is received.
Bridge Warning tone
See BroadSoft's documentation for detailed
information.
Select the type of Bridge Warning tone treatment
you prefer when you bridge and join a call using a
feature access code.
Select None
to apply no tone alert treatment upon
your entry to the call.
Select Barge-in only to provide a single tone
alert. Select Barge-in and repeat every 30
seconds to provide a tone alert at that interval.
3. Click the Edit link adjacent to the selected Line/Port to modify a specific phone that has
a Shared Call Appearance of your line.
4. Click OK.