User's Manual 3. Getting Started
Version 6.6 15 MediaPack Series
3 Getting Started
The MediaPack is supplied with application software already resident in its flash memory
(with factory default parameters). The MediaPack is also supplied with a Web interface.
For detailed information on how to fully configure the gateway refer to Device Initialization
& Configuration Files and the Web interface chapter below.
3.1 Assigning the MediaPack IP Address
To assign an IP address to the MediaPack use one of the following methods:
HTTP using a Web browser (see 'Assigning an IP Address Using HTTP' on page 16).
BootP (see 'Assigning an IP Address Using BootP' on page 17).
DHCP (see 'Using BootP/DHCP' on page 21).
Serial communication software (e.g., HyperTerminalTM) connected to the MediaPack
via the RS-232 port.
You can use the Reset button to restore the MediaPack networking parameters to their
factory default values (refer to Restoring Networking Parameters to their Initial State on
page 18).
The default device IP Addresses are shown below.
MediaPack Default IP Parameters
FXS/FXO Interfaces Default IP Address
FXS 10.1.10.10
FXO 10.1.10.11
FXS & FXO 10.1.10.10
Default Subnet Mask 255.255.0.0
Default Gateway IP Address 0.0.0.0
To Next Page
Loading...
