AudioCodes MP-112R - Creating a Login Welcome Message

User's Manual 56 Document #: LTRT-71405
MediaPack Series
4. In the searched list, click the required parameter (link in green) to open the page in
which the parameter appears; the relevant page opens in the Work pane and the
searched parameter is highlighted for easy identification, as shown in the figure below:
Note: If the searched parameter is not located, the "No Matches Found For This
String" message is displayed.
Figure 16: Searched Result Screen
6.4.7 Creating a Login Welcome Message
You can create a Welcome message box (alert message) that appears after each
successful login to the device's Web interface. The WelcomeMessage ini file parameter
table allows you to create the Welcome message. Up to 20 lines of character strings can
be defined for the message. If this parameter is not configured, no Welcome message box
is displayed after login.
An example of a Welcome message is shown in the figure below:
Figure 17: User-Defined Web Welcome Message after Login
ini File Parameter for Welcome Login Message
Parameter  Description
WelcomeMessage Defines the Welcome message that appears after a successful login to
the Web interface.
The format for this ini file parameter table is as follows:
[WelcomeMessage]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text;
WelcomeMessage 1 = "..." ;
WelcomeMessage 2 = "..." ;
WelcomeMessage 3 = "..." ;