User's Manual 68 Document #: LTRT-71405
MediaPack Series
6.5.1.2 Syslog Settings
The procedure below describes how to configure Syslog.
To configure Syslog:
1. Open the Syslog Settings page (Configuration tab > System menu > Syslog Settings).
Figure 36: Syslog Settings
2. Enable the Syslog feature by setting the 'Enable Syslog' to Enable.
3. Define the Syslog server using the 'Syslog Server IP Address' and 'Syslog Server Port'
parameters.
4. Configure the debug level using the 'Debug Level' parameter.
5. Under the 'Activity Types to Report ...' group, select the activities to report.
6. Click Submit to apply your changes.
6.5.1.3 Regional Settings
The Regional Settings page allows setting the system date and time.
To access the Regional Settings page:
Open the Regional Settings page (Configuration tab > System menu > Regional
Settings).
Figure 37: Regional Settings
To set the date and time:
1. Enter the date and/or time using the YYYY, MM, and DD field for Year, Month and
Day and HH, MM, and SS fields for Hour, Minutes and Seconds.
2. Click Submit. The date and time is set on the device, accordingly.
Note: When the NTP feature is enabled (the NTP server is defined in the
Application Settings page), the date and time are in Read Only mode as they are set
by the NTP server.
To Next Page
Loading...
